A/S
Self-checkpoint before requesting repair service
Author
DCSENG
Date
2017-12-19 15:52
Views
1312
Self-checkpoint before requesting repair service
1.In case of defective power supply
- Make sure that power supply go on smoothly.
- For instance, circuit breaker OFF and lead wire.
- Make sure of operating the main LED lightening and cooling fan. (When supplying the power, it is operating at all times)
- Make sure the side fuse of control box (15A 5Φ 20mm)
2. If the power can be supplied but not working,
- If the emergency switch is pressed (can’t use it all)
- If switch and volume lever is located in “0” (can’t use its act)
3. Pipe is not fastened during operation.
- Check the tightening condition of chain for S-500
- Make sure whether the rotation direction of S-500 material is rotating forward.
- It can be a problem when excessive entry of cutting and beveling blade, and changing the direction of blade.
4. If chain is not tightened during operation,
- Make sure that the rear hook of the machine is located in the normal operating range (upper 1/3 section of the whole section)
- Make sure that the chain fastening high speed and low speed buttons are in neutral position.
5. If the fixing blade nut is not released,
- Loosen the nut (right screw) on S-150 by rotating it counter-clockwise.
- Loosen the nut (left screw) on S-5000 by rotating it clockwise.
6. If you don’t see the laser light,
- Check the right laser switch of control box is located in “ON”
- Check the connection part and whether the cable is disconnection or not.
7. If the drop value happens, when cutting piping material.
- Check the horizontal position of equipment and piping (both guide roll gap alignment / please refer to the manual)
- Make sure that you are using the right RPM of cutting speed and rotation speed.
- Make sure whether the pipe of transfer device is contacted or not.(during operation, check the lowered position).
- Make sure that the chain is positioned according to laser pointer.
8. If alarm goes off (caused by power overload, excessive work),
- Make sure that you are using the right RPM during cutting and beveling (caused by overload).
- Replace after checking the losing its edge of the cutting and beveling blade
- If the emergency switch changes from ON to Off, it is possible to reset.
- If the power supply is removed, it is possible to return the alarm.
9. How to use cutting and beveling blade for a long time.
- If you are properly using the brush, fixing pin of the washer and anti-jamming device.
- Make sure that you are using the right RPM.
- When using lubricant during cutting and beveling according to the condition, the life of spare part can be extended. (Recommended lubricant : RTD Liquid tap fluid of ROCOL社).
10. Oil change
- S-150 : 3 months or operating time 500 hours
- S-500 : 6 months or operating time 1000 hours
- Please use 5W-40 oil(Gasoline engine oil)